Scheppach TIGER2000S, Руководство по сборке и эксплуатации

Страница: 14 / 17

INSPECTION, MAINTENANCE, AND CLEANING
1. WARNING! Make sure the Wet Grinder is disconnected from its electrical
outlet prior to performing any inspection, maintenance, or cleaning procedures.
2. Before each use: Inspect the general condition of the Wet Grinder. Check for
cracked or broken parts, damaged electrical wiring, damaged Grinding Stone or
Honing Wheel, and any other condition that may affect safe operation. If abnormal
noise or vibration occurs, have the problem corrected before further use.
Do not use damaged equipment.
3. To dress the Grinding Stone: New Grinding Stones frequently are not true and
during operation often become grooved, glazed (build-up), out of round, or
misshapen. To correct this situation, you will need a grinding stone dresser
(available from Harbor Freight Tools).
A. Make sure to stand at the side of the Grinding Stone (19) for this operation.
B. If the Grinding Stone (19) is new, allow it to spin for a minute with no load. If
the Grinding Stone spins straight and true, you will not need to dress it prior
to operation. If it does not spin straight and true, proceed with the following
instructions:
C. If you are using a “pistol grip” dresser, grip the handle firmly with one hand
and the arm of the dresser with the other hand. Allow the Grinding Stone
to reach full speed. Use the Tool Support (23) to support your hand and the
dresser, and evenly apply the dresser to all surfaces of the Grinding Stone.
The Grinding Stone can be dressed in a few minutes.
D. If you are using an “inline dresser”, hold the handle firmly. Place the
dresser on the Tool Support (23) so that its wheels can move freely (i.e., the
exposed part of the wheel should be facing up). Let the Grinding Stone
reach full speed, and apply the dresser to all surfaces of the Grinding Stone.
4. To install a new Grinding Stone: Unscrew and remove the Nut (17) and
Washer (18) that secures the Grinding Stone in place. Then, remove the old
Grinding Stone. Install a new Grinding Stone of the same type and size. Then
secure the Grinding Stone in place with the Nut and Washer.
(See Assy. Diagram.)
5. To install a new Honing Wheel: Unscrew and remove the Nut (26) and
Washer (25) that secures the Honing Wheel in place. Then, remove the old
Honing Wheel. Install a new Honing Wheel of the same type and size. Then
secure the Honing Wheel in place with the Nut and Washer.
(See Assy. Diagram.)
PAGE 1
4