Scheppach TIGER2000S, Руководство по сборке и эксплуатации

Страница: 11 / 17

2. Adjust the Tool Support (23) so that the Support Plate (16) is no more than 1/16”
from the Grinding Stone (19) or Honing Wheel (27). Then loosen the two
Knobs (15) on the Support Plate to adjust the tool blade so that its sharp edge
lightly touches the Grinding Stone or Honing Wheel.
3. Turn on the Wet Grinder, and slowly move the Support Plate back and forth
along the Tool Support to grind the tool blade. When necessary, loosen the two
Knobs (15) on the Support Plate to readjust (downward) the tool blade.
4. When finished grinding/honing the tool blade, turn off the Wet Grinder. Wait until
the machine comes to a complete stop. Then remove the tool blade. Then
remove the Support Plate (16) from the Tool Support (23). (See Figure J.)
blade (sharp end downward) in the Support Plate. Then firmly tighten the two
Knobs to secure the tool blade in place. (See Figure J, previous page.)
To Grind/Hone A Small Knife Blade:
1. If grinding/honing tools such as small knife blades, loosen the two Knurled
Screws (2) on the Holder (6). Center the Tension Plate (5) along the top edge of
the knife blade. Then firmly tighten the two Knurled Screws to secure the knife
blade in place. (See Figure K.)
2. Set the Holder (6) on the Tool Support. Adjust the Tool Support (23) downward
so that the knife blade lightly touches the Grinding Stone (19) or Honing Wheel
(27). Then temporarily remove the Holder from the Tool Support.
(See Figure K.)
3. Turn on the Wet Grinder. Grip the Holder firmly with both hands, and place the
Holder (6) on the Tool Support (23). Then slowly move the Holder back and forth
along the Tool Support to grind/hone the knife blade. (See Figure K.)
FIGURE K
TOOL SUPPORT
(23)
KNURLED SCREWS
(2)
HOLDER
(6)
CENTER TENSION PLATE
(5)
KNIFE BLADE
(
(NOT INCLUDED)
PAGE 1
1