Scheppach 5903205903, Перевод оригинального руководства пользователя

Страница: 25 / 124

www.scheppach.com
GB | 25
Old devices must not be disposed of with house -
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
disposed of at a designated collection point. This can
occur, for example, by handing it in at an authorised
collecting point for the recycling of waste electrical
and electronic equipment. Improper handling of waste
equipment may have negative consequences for the
environment and human health due to potentially
hazardous substances that are often contained in
electrical and electronic equipment. By properly dis -
posing of this product, you are also contributing to the
effective use of natural resources. You can obtain in -
formation on collection points for waste equipment
from your municipal administration, public waste dis -
posal authority, an authorised body for the disposal of
waste electrical and electronic equipment or your
waste disposal company.
14. Troubleshooting
Problem Possible cause Remedy
Engine does not run. Engine, cable or connector
defective, fuses burnt.
Have the machine checked by a specialist. Never
repair the engine yourself. Attention! Check the fuses
and replace them if necessary.
The engine starts slowly
and does not reach the
operating speed.
Voltage too low, coils damaged,
capacitor burnt.
Have the power supply company check the voltage.
Have the engine checked by a specialist. Have the
capacitor replaced by a specialist.
Engine producing
excessive noise.
Coils damaged, motor defective. Have the engine checked by a specialist.
Engine does not reach
full power.
Circuits in the network are
overloaded (lamps, other engines,
etc.)
Do not use any other devices or engines on the same
circuit.
Motor overheats easily. Overloading of the engine,
insufficient cooling of the engine.
Avoid overloading the engine during grinding and
remove dust from the engine to ensure optimum
engine cooling.