www.scheppach.com
+(49)-08223-4002-99
+(49)-08223-4002-58
30
GB
Troubleshooting
Fault
Possible cause
Remedy
Motor does not work.
Motor, cable or plug defective,
fuses burnt.
Arrange for inspection of the machine by a spe-
cialist. Never repair the motor yourself. Danger!
Check fuses and replace as necessary.
The motor starts up slowly
and does not reach operating
speed.
Voltage too low, coils damaged,
capacitor burnt.
Contact the utility provider to check the voltage.
Arrange for inspection of the motor by a special-
ist. Arrange for replacement of the capacitor by a
specialist.
Motor makes excessive noise. Coils damaged, motor defective.
Arrange for inspection of the motor by a specialist.
The motor does not reach its
full power.
Circuits in the network are over-
loaded (lamps, other motors, etc.).
Do not use any other equipment or motors on the
same circuit.
Motor overheats easily.
Overloading of the motor, insuffi
-
cient cooling of the motor.
Avoid overloading the motor while cutting,
remove dust from the motor in order to ensure
optimal cooling of the motor.
Reduced cutting power when
sawing.
Saw blade too small (ground too
much).
Readjust end stop of the saw unit.
Saw cut is rough or wavy.
Saw blade dull, tooth shape not ap-
propriate for the material thickness.
Resharpen saw blade and/or use suitable saw
blade.
Workpiece pulls away and/or
splinters.
Excessive cutting pressure and/or
saw blade not suitable for use.
Insert suitable saw blade.
Service information
Please note that the following parts of this product are subject to normal or natural wear and that the following parts are
therefore also required for use as consumables.
Wear parts* carbon brushes, saw blade, batteries, table inserts, dust bag, drive belt
* Not necessarily included in the scope of delivery!
