FLYER ON THE LEFT
FLYER ON THE RIGHT
-6-
5.
Install the front frame by sliding the threaded end of the axle through the front axle bearing (attached
in Step 1.2).
6.
Attach the wide leg of the front frame to the wide leg brace using the 40 mm frame bolts and black
barrel nuts.
7.
Attach the front axle washer and a 3/8-16 thin lock nut to the axle, tightening the lock nut only hand-
tight at this time.
8.
Remove a wing nut from the third hand assembly. Feed the plastic screw through the center hole on
the narrow legs of the frames. Slide the wing nut back over the plastic screw and then tighten the wing
nut until the narrow frame legs are in position against the narrow leg brace.
9.
Attach the narrow leg of the front frame to the narrow leg brace using the 30 mm frame bolts and
black barrel nuts. Remove the third hand assembly.
10.
Tilt the wheel up on your work surface so that it is resting on the rim of the wheel and the wide legs
of the frame. Using #6-18 x 1/2" screws, attach the rubber feet into the holes drilled in the bottom of the
frame sides and narrow leg brace. Do not over-tighten or the screws will strip the holes.
rubber foot
#6-18 x 1/2"
screw
2.10
40 mm
frame bolt
front axle
washer
barrel nut
(black)
3/8-16 thin
lock nut
2.5–2.7
third hand
screw and wing nut
30 mm
frame bolt
30 mm
frame bolt
third hand
wing nut
barrel nut
(black)
2.8–2.9
