FLYER ON THE LEFT
FLYER ON THE RIGHT
-5-
2. ASSEMBLING THE FRAME [Parts bag #2]
1.
Attach the wide leg brace to the inside of the rear frame using the 40 mm frame bolts and black barrel
nuts. Tighten until snug but do not create any bend in the frames until directed to tighten all bolts in
Step 3.3.
2.
Attach the narrow leg brace to the inside of the rear frame using the 30 mm frame bolts and black
barrel nuts. Tighten until snug.
front axle
bearing (small)
10-24 x 1.25"
machine screw
10-24
lock nut
(black)
#8 flat
washer
(black)
10-24 beveled
barrel nut
(chrome)
front frame
1.2
2.
Attach the front axle bearing (small) to the outside of the front frame using the remaining parts from
bag #1. Do not fully tighten until after wheel alignment in Steps 10.1–10.3.
3.
Slide the open end of the drive wheel axle through the rear axle bearing (attached in Step 1.1).
4.
Option:
If you plan on using the cotton double drive band, remove the installed poly drive band from
the wheel now.
drive
wheel
assembly
2.3
30 mm
frame bolt
barrel nut
(black)
rear
frame
40 mm
frame bolt
2.1–2.2
