– 8 –
– PB –
FIGURE 10B: STROLLER BAR ON WOLF PUP LT
I
1/4-20 x 1-1/2"
hex bolt
stroller bar
lock nut
washer
FIGURE 10A: STROLLER BAR ON WOLF PUP 8.10
I
1/4-20 x 1-1/2"
hex bolt
stroller bar
washer
lock nut
position. Repeat with a second caster
block and the other outside leg
height extender block.
9.
Insert a 1/4-20 x 1-1/2" Phillips
truss head machine screw into
the top hole [H] of a caster block
(Figure 9). The screw will thread
into an insert in the height extender
block that you cannot see; fasten
securely. Repeat for the other
outside leg height extender block.
10.
Attach the stroller bar to the
rear caster block: From the inside
of the loom, insert a 1/4-20 x 1-1/2"
hex bolt through hole [I] in the rear
caster block. Place a washer on the
hex bolt and then place the round
hole at the end of the stroller bar
over the bolt. For Wolf Pup 8.10
looms, the jog in the stroller bar
must point
outward
(Figure 10A).
For Wolf Pup LT looms, the
job in the stroller bar
must point
inward
(Figure 10B). Secure
the hex bolt with a
1/4-20 lock nut, using
a 7/16" wrench to
attach the lock nut. Tighten the
lock nut securely enough to hold
the stroller bar in place, but loosely
enough for it to pivot. Repeat for the
other rear caster block.
•
