– 4 –
– 5 –
InstAllAtIon
on
b
Aby
W
olf
&
m
IgHty
W
olf
H
eIgHt
e
xtender
looms
1.
Install the Wolf Stroller on a hard
surface. Open the loom to weaving
position (see front cover illustration).
2.
Set the treadle support on a block
of wood or a few books to elevate the
loom front about two inches. Remove
the machine screws and barrel nuts that
hold the treadle support to the inside
legs at hole [A] (Figure 2). Save the
barrel nuts for the next step.
3.
Set a caster block on the outer side
of an inside leg, with the caster wheel
toward the front and the floor (Figure
3). Line up hole [D] at the bottom of
the caster block to hole [A] in the leg.
Insert a 1/4-20 x 3-1/2" Phillips truss
head machine screw through the bottom
hole [D] in a caster block, then through
the bottom hole of an inside leg height
extender block (Figure 3). Thread the
machine screw into a barrel nut in the
treadle support and tighten, using a
slotted screwdriver to hold the barrel nut
in position. Repeat with a second caster
block and the other inside leg.
4.
Insert a 1/4-20 x 1-1/2" Phillips truss
head machine screw into the top hole
[E] of a caster block (Figure 3). The
screw will thread into an insert in the
height extender block that you cannot
FIGURE 3: FRONT CASTER BLOCK AND INSIDE
LEG
E
D
F
1/4-20 x 3-1/2"
Phillips truss
head machine
screw
1/4-20 x 1-1/2"
Phillips truss head
machine screw
1/4-20 x 1-3/4"
hex bolt
washer
lock
nut
wing nut
FIGURE 2: MIGHTY WOLF AND BABY WOLF LEGS
treadle
support
A
C
C
B
rear leg
brace
inside leg on
right side of loom
outside leg on
right side of loom
barrel nut
(save)
