– 6 –
– 7 –
1.
Install the Wolf Stroller on a hard
surface. Open the loom to weaving
position (see front cover illustration).
2.
Set the treadle support on a block
of wood or a few books to elevate the
loom front about two inches. Remove
the machine screws and barrel nuts that
hold the treadle support to the inside
legs at hole [A] (Figure 6). Save the
barrel nuts for the next step.
3.
Install the Wolf Stroller on a hard
surface. Open the loom to weaving
position (see front cover illustration).
4.
Set the treadle support on a block
of wood or a few books to elevate the
loom front about two inches. Remove
the machine screws and barrel nuts that
hold the treadle support to the inside
legs at hole [A] (Figure 6). Save the
barrel nuts for the next step. Set a caster
block on the outer side of an inside leg,
with the caster wheel toward the front
and the floor (Figure 7). Line up hole
[D] at the bottom of the caster block
FIGURE 7: FRONT CASTER BLOCK AND INSIDE
LEG
D
E
1/4-20 x 3-1/2"
Phillips truss
head machine
screw
1/4-20 x 1-1/2" Phillips
truss head machine screw
NOTE: If you installed the wheels that came with your loom, we
recommend that you take them off before installing your Wolf Stroller.
InstAllAtIon
on
W
olf
P
uP
8.10
&
W
olf
P
uP
lt
H
eIgHt
e
xtender
looms
FIGURE 6: WOLF PUP 8.10 AND LT LEGS
treadle
support
rear leg
brace
inside leg on
right side of loom
outside leg on
right side of loom—
8.10 brake release pedal not shown
barrel nut
(save)
C
C
barrel nut
(save)
B
A
