SCARAB MINOR Euro 3
Original Issue - 19 August 2003
Operator’s Manual
Page 15
DESCRIPTION OF SWEEPING CONTROLS
SWEEP MODE SWITCH.
Two-position key switch.
CAUTION:
Before selecting Sweep Mode, turn the suction fan OFF. The engine will
stall if Sweep is selected with fan ON with engine-speed controller at 0.
Position 1 (Sweep) - gives a sweep-speed range of 0 - 10 mph (0 - 16 kph).
The green Sweep Mode indicator will illuminate.
Position 0 (Drive) - gives a driving-speed range of 0 - 40 mph/0 - 65 kph).
When Drive Mode is selected the Sweep Mode indicator will extinguish.
CAUTION:
Always turn the Sweep Mode Switch to 0 after sweeping operations.
ENGINE-SPEED ADJUST
. Rotary potentiometer used to preset engine-
speed for sweeping, it has a bezel marked 1 to 10. Turning clock-wise
increases engine speed. Used with the Sweep Monitor (page 20).
Fig. 11 LHD Control Panel Layout (right-hand-drive panel is mirror image of this)
FUEL
GAUGE
GLOW PLUG
INDICATOR
IGNITION
LIGHT
BRUSH
SIDE BRUSH
WIDE SWEEP
ON/OFF
SUCTION
FAN ON/OFF
NEARSIDE FRONT
BRUSH ON/OFF
OIL
LIGHT
BRAKE
FLUID
SWEEP MODE
CRUISE CONTROL
INDICATOR
CRUISE CONTROL
BUTTON
SIDE BRUSH
SPRAY
FRONT BRUSH
SPRAY
WIDESWEEP
SPRAY
HOPPER TIP
WORKLIGHTS
HIGH-PRESSURE
FORWARD/
REAR FOG LAMPS
ENGINE
SPEED
SWEEP MODE
KEY SWITCH
BEACON
RADIO
WATER
MAIN BEAM
WARNING
PUMP*
REVERSE LEVER
GOBBLER FLAP
FRONT BRUSH
SWING OUT
TURN INDICATOR
REPEATER
TEMP
ON/OFF
MASTER
SWITCH
SWEEP
MONITOR
HEATER FAN
SWITCHES ON DOOR
NOTE:
The control panel illustrated is
for a Left Hand Drive machine.
Right hand Drive panels are
the reverse of this layout.
& INDICATORS
OFFSIDE FRONT
BRUSH ON/OFF
AIR CON
Continue...
drivemanVM.fm Page 15 Tuesday, August 19, 2003 11:43 AM
