Scantronic 9449, Руководство пользователя

Страница: 4 / 8

Anti - code
? ? ? ?
6
#
ENTER
Your Existing Code No.
Followed by:
The Code to be Changed.
Two Bleeps from
Sounder
The New Four Digit Code
Two Bleeps from
Sounder
4 #
ENTER
? ? ? ?
5 #
ENTER
? ? ? ?
Trigger Detectors (Not Panic
Alarm)
? ? ? ?
3
The central station will give you a new four digit
code, the “anti-code”, note it down.
5. Enter the code given by the central station.
The Service light goes out.
6. Key in your user code. The system is now ready
for use.
TO CHANGE YOUR USER CODE
Your system provides two separate four digit user
codes. When the system is new, the user codes are
“1234” and “0000”. Change the “1234” user code
immediately to a number that only you know. The
new code can be ANY four digit code you choose.
The “0000” user code is inactive and will not
operate the system. To activate the second user
code change the “0000” to another four digit
number. Do not use the same number for both user
codes. To inactivate the second user code again,
change it back to “0000”.
Duress Code: Your system provides a Duress
Code. When the system is new the code is inactive,
and set to “
✽✽✽✽
”. To activate the code change it to
a number you can remember, using the same
method as changing the access codes. Do not use
“9999” or the same number as your other access
codes. To inactivate the duress code change it back
to “
✽✽✽✽
”. If your system is connected to a central
station, then it will send a silent signal when you
unset your system using the duress code.
TO TEST BELLS
Make sure system is unset before starting the test.
Key in 4 then ENTER followed by your user code.
The internal sounders will operate for three seconds
and then the external sounder and strobe will
operate for 10 seconds.
TO WALK TEST
Key in 5 then ENTER, followed by your user code.
The internal sounder gives a steady tone.
Open and close the Exit/Entry zone and Zones 1 to
7. Each time you open a zone, the zone light
flashes and the internal sounder gives a pulsing
tone.
You cannot test the 'Tamper Circuits', fire alarms,
24 Hour zones or panic buttons without causing an
alarm.
To stop a walk test, key-in your access code.
496281 Issue 1