Scantronic 9449, Руководство пользователя

Страница: 5 / 8

Repeat for each zone
Zone
No.
✽ ✽
✽ ✽ ✽
OMIT
? ? ? ?
7
#
ENTER
"beep"
? ?
"beep"
? ?
Fault
Service
? ? ? ?
8
#
ENTER
? ? ?
Zone or Tamper
?
EARLIER
1 3
LATER
✽ ✽
✽ ✽ ✽
OMIT
TO OMIT A DETECTOR
You may need to temporarily set the system with
one or more detectors omitted. Key in the zone
number followed by OMIT for all the zones you want
to omit and then key in your user code. The system
flashes the light(s) of the omitted zone(s) during the
exit time and then sets. Note that you cannot omit a
panic button, nor can you omit a 24 hour zone while
the system is unset.
The system will not raise an alarm if any omitted
detector is triggered during this setting cycle. The
system will reinstate the detector(s) and set nor­
mally the next time you set the system.
TO SWITCH CHIME ON OR OFF
Key in 7 then ENTER, followed by your user code to
switch Chime on or off. When Chime is on, the
internal sounder chimes when the chime zones
operate. Note that the Installer must program your
chime zones.
TELEPHONE LINE FAILURE
If you see the Fault and Service LEDs flashing, and
a short tone every few seconds then the system has
detected a fault on the telephone line connecting
the system to the central station. Key in your user
code to stop the tone. The Fault and Service LEDs
will continue to flash until the telephone line fault is
corrected.
DISPLAYING THE LAST 10 EVENTS
You can display the ten most recent alarms and
tampers stored in the system’s log.
Key in 8 plus ENTER followed by your user code.
The display shows the most recent zone to cause
an alarm, or lights the Tamper LED.
Key in 1 to show earlier events or 3 to see more
recent events. The display shows earlier and later
alarms/tampers. The keypads give a short tone
when you reach the end of the log.
Press OMIT or ENTER to leave the log.
KEYPAD PA
You can start a Panic Alarm by pressing keys 1 and
3 together on the keypad.
496281 Issue 1 4