12
Proscan 2200 (Chromatic Sensor) User Manual V.4.0
3.5. Main Power Connection
Once the cables are all firmly connected and suitably supported, power can be applied to the
system, via the 10 Amp fused IEC connector on the rear panel of the PSU Module. A spare
20mm T 10A fuse is located in the connector fuse carrier, should it be required.
The system is switched on using the POWER
ON rocker switch, immediately next to the
IEC power inlet socket, and alongside the
Serial Number label.
3.6. Switching On
Keep fingers and objects clear of the stand when powering
the system for the first time !!
Once all the cables are in place and all objects are clear of the stand, it is safe to switch the
system on.
On switching on the PSU module, the 5 and 24V LED indicators on the front of the Module
should illuminate.
Correct booting of the Artemis board is indicated by the regular flashing of the
‘BOOTING’
light. This light will start flashing almost immediately upon powering up. Once flashing, the
system is ready to use
Ideally, allow the sensor a few minutes to temperature stabilize.
Keep fingers and objects clear of the stand when entering
software !!
