Scantool TSM 650, Руководство пользователя

Страница: 4 / 13

3
1. Transport & handling
1.1 Transport
SCANTOOL TSM 650 is delivered on a pallet with the following measurements:
120 x 80 x 86 cm 85 kg
The shears are wrapped in protective film/wrapping and the measuring bars are
supplied non-fitted.
1.2 Handling
SCANTOOL TSM 650 can easily be transported on the pallet on which it is
delivered.
1.3 Placing
Placing of the SCANTOOL TSM 650 must take place on a firm and level surface
such as a work table or the concrete. The shears must be secured to the floor by
using the four fittings which were also used for tightening the shears to the pallet.
On the back of the shears the back stop is mounted as shown in
fig. 1.1.
The back stop is mounted in the fittings. To adjust the back stops to the correct
position loosen the handles (A) and the pointed screw (B). The back stop is
pushed towards the lower knife and then the measuring bars are reset (C). The
pointed screws (B) can now be tightened. Finally the protection film is removed
from the protection plate (D).
Fig.1.1
A B
C
D