Users / service manual for Scanomat Top Juicer
Vibe Allé 3 • Postboks 131 • 2980 Kokkedal.
Phone +45 49 18 18 00 • www.scanomat.dk
10
Water connection:
When the water supply is being established please make sure that the equipment is not situated on the
rear end of the water supply system to ensure continuous supply of fresh water.
1.
Connect the equipment to the cold water line, which is equipped with an adjustable check valve
(1/2” external screw thread). Before connecting the equipment draw off some buckets of water to
clean the pipes. If the water is not good quality we recommend that a Scanomat water filter is
installed.
2.
Fasten the hose nipple to the valve
3.
Turn on the water and make sure that all joints and connections are tight.
Note:
After long periods of inactivity (holidays or weekends) when the equipment has not been in operation
for some time the water will loose its quality, therefore we recommend activating the “clean
programme”, perhaps a couple of times, in order to get fresh water.
It is important that the inlet water supply is a primary supply with its own ‘stopcock’ this is to ensure
that during daily operation there is a constant water pressure at the inlet.
