SCANMASKIN Scan Combiflex 700, Руководство пользователя

Страница: 34 / 56

Scan Combiflex 700 – Manual
Chapter 5
- 28 -
5.4 Grinding disc replacement / assembly
Follow these steps to replace the Scan-On plate

Make sure the machine is in its “Safety off position” as described in “
2.7 Definition of the
“Safety off position” ”

Tilt the machine backwards and secure it.
 Remove any tools used as described in “
4.9 Changing tools
”.

Loosen the three screws holding the Scan-On plate.

Replace the Scan-On plate.
 It’s recommended that new screws are used to fasten the replacement Scan-On plate.
 It’s also recommended that copper paste is used on the surface of the screw hole at the Scan-On
plate.

Tighten all screws by hand and make sure that they are secured.
5.5 Cleaning the machine
Before starting to clean the machine, make sure it is in its ”Safety off position”
The power must not be connected while cleaning the machine.
Do not use highly pressurized water to clean the machine.
Water and soap is recommended.
5.6 Trouble shooting
5.6.1 Grinding related faults
Symptom Cause Correction A
7
The machine won’t start 
There is a power failure from the power supply

Inspect the fuses in the worksites fuse box

Inspect cables

Measure that all three phases are present and at full voltage
near the machine
O
E
E

The emergency stop button is depressed

Release the emergency stop button. O

Internal error

If possible, read the alarm or fault code present at the display
inside of the electrical cabinet. Alarm codes are formatted as
“Axxxx” where “x” is the number. Fault codes are formatted
as “Fxxxx”.

Contact Scanmaskin Sweden AB
O
The machine is weak and
might stop when on the
ground.

One of the three phases are missing from the
power supply

There is a voltage drop at the power supply

Inspect the display on the inverter for any alarm code

Inspect the fuses in the worksites fuse box

Inspect cables

Measure that all three phases are present and at full voltage
at the cable end near the machine.

Make sure that the cable is not to long. If the cable is to long,
use a cable with higher rating to a distribution box near the
machine.
O
O
E
E
O
The machine vibrates a lot

The grinding speed is to high

Lower the speed O

The tools are damaged

Inspect the tools

Change the tools if needed
O
O
Table 5-1 Common faults - general
7
See access table ”Table 5-5”