SCANMASKIN Scan Combiflex 700, Руководство пользователя

Страница: 31 / 56

Scan Combiflex 700 – Manual
Chapter 4
- 25 -
4.6.8 Automatic drive
 Make sure that the joystick (1) is on according to “
4.5.7.4 Start up
”.
 Select proper speed mode according to “
4.5.7.5 Speed modes” .
 Turn the “TRACKING” knob (11) to its centre position.

Set the drive mode selector (9) to “FORWARD” or “BACKWARD”
 Use the “FORWARD SPEED” knob (10) to adjust the drive speed and the “TRACKING”
knob (11) to adjust the drive direction.
4.6.8.1 Stop automatic drive

Set the drive mode selector (9) to “N” (neutral).
4.6.8.2 Joystick during neutral drive mode
The joystick (5) can be used to adjust the direction while automatic drive is enabled.
When in neutral the joystick works in the same fashion as the joystick on the control panel.
4.6.8.3 Radio LED indications
Mode
Event Indication
System OK
Not connected Fast green 50/50ms
Joystick not in centre position. (at start up) Slow green 30/970ms
Connected Yellow 150/300ms
Empty battery Steady yellow for 10 seconds
ERROR Transmitter internal error Steady red for 10 seconds
4.6.8.4 Radio Display indications
Antenna symbol indicates radio-link
established A crossed antenna is showed if radio
communication is lost.
Exclamation mark indicates loss of contact
between the receiver and the motor drive Selected error codes from the motor drive
are showed at the right side.
4.7 Safety off position
When working on the machine, either maintenance or tool change, the machine must be set to the
“Safety off position”. See “
2.7 Definition of the “Safety off position”
” for further information.