SCANMASKIN FEROX 200, Руководство пользователя

Страница: 10 / 32

10
www.scanmaskin.com
tampered with, stripped down or adjusted, otherwise it will invalidate the warranty. The starter control
box lid must be unscrewed to gain access to the Black reset button,
ensure that the supply is
disconnected prior to opening the lid .
110v Motor
Use a centre tap transformer with a continuous rated output of 5.0KVA and must be a 230v 20amp
supply.
Do not add an extension lead to the transformer input.
Do not use a 230v 13amp domestic supply.
The motor requires the minimum of a 32amp, 110v power supply.
To avoid voltage drop the machines extension cable must also be 4.0mm2 cross-section with a
maximum length of 30 meters.
240v and 415v Motors
Take particular care when using 240v or 415v Machines, ensure that the electrical supply is earthed and
that breakers and fuses are correct for the loading. The 240v motor requires the minimum of a 13amp,
220v power supply. The 415v motor requires the minimum of a 10amp, 380v power supply. Always use
the shortest possible length of extension cable. To avoid voltage drop the cable must be a minimum of
2.5mm. Maximum length of cable 30 meters.
2.4 Starting Petrol Engines
Before starting work ensure that the Cutter Drum is clear of the ground by releasing the adjustment
clamp lever and raising the handle, then re-clamp.
Check that there is sufficient fuel in the fuel tank. (See manufactures hand book for type)
Check that the engine oil level is correct. (See pre-start check)
Open the engine fuel cock.
Set the throttle lever on the engine to half open position.
For cold engine starting, move the carburettor’s choke lever to the choke "full on" position. (5.5hp
engine)
Check that the engine stop switch is in the "on" position.
Pull the ‘Deadmans’ handle towards the handle bar and hold in position. (The motor will stop
immediately if this lever is released
IMPORTANT
Do not pull the recoil starter cord to the end of is travel as it may cause damage to the
engine or injury to the operator.
When the engine starts, recoil the cord slowly.
Do not allow the cord to snap back to its start position.