SCANMASKIN FEROX 200, Руководство пользователя

Страница: 27 / 32

27
ENGLISH
FEROX 200
www.scanmaskin.com
8 Trouble shooting
TROUBLE SHOOTING
FAULT CAUSE ACTION
Engine stops suddenly or
does not run correctly
No fuel in the fuel tank. Refuel fuel tank. (See safety
section.)
Spark plug faulty. Replace spark plug.
Fuel blockage. Check fuel line and strainer.
Air cleaner blocked. Replace air cleaner element.
Low oil level. (A low oil
cut out is fitted) Rectify leaks and replenish
oil.
Electric motor stops
suddenly
Blown electrical supply
fuse. Replace fuse.
Motor overload
protection activated Disconnect electricity supply
at mains and reset button
inside starter box.
Electric motor will not start Deadmans handle not
engaged Pull Deadmans lever against
handle bar and press start
button.
Planer is slow or erratic
Drive Belt slack or failed.
Replace Belts or adjust
tension.
Worn Drum Cutters Replace Cutters.
Loose or a failed drive
belt.
Replace Belts and adjust
tension.
Surface too rough Use Scanmaskin Ferox 300
Scarifier to increase
production
Low air supply or air
pressure Requires a minimum of
160cfm @ 90psi
No fuel in the fuel tank. Refuel fuel tank, see safety
precautions.
Engine will not start Low oil level. Rectify leaks, replenish oil.
Water in fuel/wrong fuel
type Drain fuel tank, float
chamber, and refuel with
correct fuel type.
Spark plug faulty. Replace spark plug.
Engine will not turn over Oil in Cylinder. See section. 1 - Safety
Precautions.
Use above information in conjunction with the engine manufacturers Operation and Maintenance Manual.
If problem has not been cured by above actions, contact your local Scanmaskin agent or engine manufacturer for
advice or rectification.