5
/
11
INSTRUCTION MANUAL JUMP STARTER SC POWER SC15
INSTRUCTION MANUAL JUMP STARTER SC POWER SC15
3.
ONCE THE CHARGE IS FINISHED, PLEASE DISCONNECT THE CHARGER FROM THE POWER SOURCE
AND DETACH THE DC PLUG FROM THE DEVICE.
4.
THE DEVICE IS PROTECTED FROM EXTREME TEMPERATURE, SO IT IS NOT RECOMMENDED TO
OPERATE AT AMBIENT TEMPERATURE LOWER THAN -20
℃
OR HIGHER THAN +45
℃
. IN FACT THE
OPERATION MAY NOT BE ACTIVATED OR MORE CRANK ATTEMPTS MAY BE NECESSARY.
MOREOVER, THE CHARGING PROCEDURE WILL NOT START IF THE TEMPERATURE OF THE
BATTERY PACK IS EXCEEDING THE RANGE FROM 3
℃
TO 40
℃
.
5.
MALFUNCTION – BATTERY INDICATOR WILL BE FLASHING SIMULTANEOUSLY AS PROTECTION
CIRCUIT HAS BEING ACTIVATED. PLEASE FIX THE PROBLEM BEFORE TURN ON THE DEVICE
AGAIN.
CONDITION BEFORE USE
Ensure the below conditions are guaranteed before pressing the JUMP START button.
1.
Ensure the capacity of the battery is full
Jump Start can only be used when the spectrum
lights up to GREEN or YELLOW.
3.
Ensure the contact terminals of the car battery are clean.
Erase any corroded substance from battery terminals and
ensure correct contact point at the clip. Please note that the
battery terminals must be properly connected before pressing
the JUMP START button.
