8
Figure 16
Figure 17
11. INSTALLING THE LIGHT
KIT
NOTE:
Before starting installation,
disconnect the power by turning off the
circuit breaker or removing the fuse at
fuse box. Turning power off using the fan
switch is not sufficient to prevent electric
shock.
Step 1.
Remove the 1 of 3 screws from the
mounting plate and keep it for future use.
Loosen the other 2 screws (Do not
remove)
Step 2.
Raise and hold the light kit close
to the mounting plate and proceed to do
the wire connections. Connect the white
wire connectors from the light kit and fan,
follow the same procedure with the black
wire connectors. (Fig. 16)
S
tep 3.
Tuck connections neatly into
mounting plate, Place the light plate key
holes over the 2 screws previously
loosened from the mounting ring, turn
light kit until it locks in place at the narrow
section of the key holes. secure by
tightening the 2 screws previously
l o o s e n e d a n d t h e o n e p r e v i o u s l y
removed. (Fig. 16).
12. INSTALLING THE GLASS
SHADE & LIGHT BULBS
1. Install 3 x40w candelabra bulbs
(included). (Fig. 17)
2. Place the glass shade and glass frame
to the light kit with the decorative
cover and decorative nut provided. DO
NOT OVER TIGHTEN. (Fig. 17)
3. Restore power and your light kit is
ready for operation.
Mounting plate
Connection plugs
Light kit
Screws
Light kit
Bulbs
Glass shade
Glass frame
Decorative cover
Decorative nut
