REMEMBER
to turn off the power. Follow the
steps below to hang your fan properly:
Step 1.
Pass the 120-volt supply wires
through the center hole in the ceiling hanger
bracket as shown in Fig. 5.
Step 2.
Secure the hanger bracket to the
ceiling outlet box with the screws and
washers provided with your outlet box. (Fig. 5)
Step 3.
Remove the hanger pin, lock pin and
set screws from the top of the motor
assembly. (Fig. 6)
Step 4.
Route the safety cable and wires
exiting from the top of the fan motor through
the decorative scroll assembly, canopy cover,
canopy and then through the ball / downrod.
(Fig. 6)
Step 5.
Route wires exiting from the top of the
fan motor through the canopy and then
through the ball / downrod.
Step 6.
Align the holes at the bottom of the
downrod with the holes in the collar on top of
the motor housing (Fig. 6). Carefully insert the
hanger pin through the holes in the collar and
downrod. Be careful not to jam the pin against
the wiring inside the downrod. Insert the
locking pin through the hole near the end of
the hanger pin until it snaps into its locked
position, as noted in the circle inset of Fig. 6.
Step 7.
Tighten two set screws on top of the
fan motor firmly. (Fig. 6)
Step 8.
Place the downrod ball into the
hanger bracket socket. (Fig. 7 )
5. HANGING THE FAN
4
Figure 5
Figure 6
Figure 7
Registration slot
Downrod
Canopy
Set screws
Hitch pin
Lock pin
120V Wires
CUL Listed
electrical box
Hanger
bracket
Hook
Mounting screws
(supplied with
electrical box)
Safety cable
