7
9. INSTALLATING
THE MOUNTING PLATE
1. Remove the 1 of 3 screws from the
mounting ring and loosen the other 2
screws. (Do not remove)
2. Place the key holes on the mounting plate
over the 2 screws previously loosened
from the mounting ring, turn mounting
plate until it locks in place at the narrow
section of the key holes. Secure by
tightening the 2 screws previously
l o o s e n e d a n d t h e o n e p r e v i o u s l y
removed. (Fig. 13)
Figure 13
Figure 14
Mounting
plate
Mounting ring
Screws
10. INSTALLATING THE
LIGHT KIT TO THE
SWITCH HOUSING
1. Remove and discard the center plug from
the switch housing.
2. Attach the light kit to the switch housing
by feeding the light kit wires (black and
white) through the hole of switch housing
and then screw it onto the switch housing by
nut & lock washer. Be sure it is tight enough
to prevent light kit from vibrating loose.
3. Make sure the white wire from the light kit
connected to the white wire from switch
housing, and black wire from light kit
connected to the blue wire from switch
housing. (Fig. 14)
Switch housing
Plug
Lock washer
Light kit
Wire nuts
Nut
