6
8. FINISHING THE
INSTALLATION
Step 1.
Tuck connections neatly into
ceiling outlet box.
Step 2.
Slide the canopy up to hanger
bracket and place the key hole on the
canopy over the screw on the hanger
bracket, turn canopy until it locks in place
at the narrow section of the key holes.
Step 3.
Align the circular hole on canopy
with the remaining hole on the hanger
bracket, secure by tightening the two set
screws.
Note:
Adjust the canopy screws as
necessary until the canopy and canopy
cover are snug. (Fig. 11)
Warning:
Make sure tab at bottom of
hanger bracket is properly seated in
groove of hanger ball before attaching
canopy to bracket. Failure to properly seat
tab in groove could cause damage to
electrical wiring.
Figure 11
Outlet box
Hanger
bracket
Canopy
Canopy cover
Screws
Figure 12
9. ATTACHING THE FAN
BLADES
Step 1.
Align the holes from the blade to
the holes from the motor, and secure the
blade in place with screws, wahers and
and lock wahers provided. (Fig. 12)
Step 2.
Repeat this process to attach the
other blades.
Blade
Washers
Lock washers
Screws
