9
Figure 16
Figure 17
11. INSTALLING THE
LIGHT BULBS & GLASS
SHADE
1. Install 3 x 40W candelabra bulbs
(included).
2. Insert the fan pull chain through the
eyelet in the shade and cap. Also insert
the light kit pul chains through the
shade and cap. (Fig. 17)
3. Remove the metal nut, glass cap and
decorative nut from the light kit. Place
glass shade over the light kit stem,
secure with the metal nut, glass cap and
decorative nut. Do not overtighten. (Fig.
17)
Note:
Make sure to leave enough space
between the fan pull chain and the bulbs
so the chain doesn't rub against any of the
bulbs.
10. INSTALLING THE
LIGHT KIT
NOTE:
Before starting installation,
disconnect the power by turning off the
circuit breaker or removing the fuse at
fuse box. Turning power off using the fan
switch is not sufficient to prevent electric
shock.
1. Remove the screws from the mounting
plate under the fan motor.
2. While holding the light kit assembly
under your fan, snap together the wire
connection plug. (Fig. 16)
3. Raise the light kit to the mounting plate
until the holes in light kit and mounting
plate line up. Reinsert screws to secure in
place. (Fig. 16)
Mounting
plate
Connection plugs
Light kit
assembly
Screws
Light kit
Bulbs
Pull chains
Glass shade
Decorative nut
Glass cap
Metal nut
