SHA-B5Wxx-00 | 009-1649-00 | 180411
Copyright 2018 Savant Systems, LLC
45 Perseverance Way, Hyannis, MA 02601
| 508.683.2500
2 of 2
5. Screw the mounting sleeve onto the hanger bolt until the hex head set screw in the
sleeve is positioned slightly offset from the hole in the shade mount (see diagram).
Leaving the set screw offset will allow the shade mount to be pulled tight to the wall
in the next step.
6. Slide the shade mount over the sleeve until the set screw is visible through hole on
side of mount. With 3/32 inch hex key, turn the set screw counterclockwise to back
off the set screw a bit until it rests within the hole on the side of the mount. This will
pull the mount tight against the wall or ceiling.
Leave set screw
offset from hole
in shade mount
as shown
Mount Sleeve
7. Verify shade mount is tight to the wall. If not, turn in the set screw, remove the shade mount, and adjust the mounting sleeve to ensure the
mount is pulled tight to the wall or ceiling.
