3
009-1593-02
– Pencil
– #2 Phillips screwdriver
– Small slotted screwdriver
– Drill with
5/32
inch drill bit
– Wire stripper
– Needle-nose pliers
– Hammer (if wall anchors are used)
Welcome
Getting Started
Location and Mounting Overview
The following is needed for a trouble free installation:
This document describes how to:
1. Remove the old thermostat.
2. Mount your new CLI-W200 thermostat.
3. Wire your new CLI-W200 thermostat.
CAUTION!
When replacing an older thermostat that
contains Mercury in a sealed tube, do not discard into trash.
Refer to the thermostat-recycle.org website for information
on how to properly dispose.
For new installations or when relocating the thermostat,
follow the guidelines below:
– Locate thermostat on an inside wall.
– Do not locate where air circulation is poor such as in a
corner or behind a door.
– Do not locate near windows or doors to reduce the expo-
sure to drafts.
– Install away from any heating conditions such as direct
sunlight, near a radiator register or vent, or near a fireplace.
– To adhere to ADA requirements, install thermostat 48 - 54
inches (1.22 - 1.37 meters) above the floor.
– Height requirements can be adjusted upward to 60 inches
(1.5 meters) if ADA requirements are not mandatory.
– The thermostat does not need to be level to operate cor-
rectly. Leveling the thermostat is for aesthetics only.
– Thermostat can be oriented in either a portrait or land-
scape layout.
