5
009-1593-02
Install Thermostat Mounting Plate
1. To separate the thermostat from its mounting plate, grasp
the mounting plate in one hand and the thermostat in the
other (Grasp the end opposite the proximity sensor).
2. Rock the top and bottom halves until they separate.
3. Position the thermostat mounting plate onto the wall.
With a pencil, mark the two mounting holes onto the wall
(See image above).
– When mounting using a portrait layout, use the bubble
level installed in the center of the mounting plate to
level.
– When mounting using a landscape layout, remove
bubble level by pushing it out through the rear of the
mounting plate and reinstall it into the bubble level slot
on the right side of center cutout. See diagram above.
4. Drill a
5/32
inch hole on each mark made and tap the wall
anchor into wall until flush. In some installations that have
a sub wall to fasten to, wall anchors may not be required.
5. Pull the existing wires through the center cutout in the
mounting plate.
6. Screw the mounting plate to the wall using the supplied
#8 x
3/4
inch screws.
Bubble level slot
(Portrait)
Bubble level slot
(Landscape)
Pull wires through
the center opening
Install Anchors
into Drywall
#6 x 3/4 inch
screws
Install Anchors
into Drywall
UP
