ASV115
8/13
www.sauter-controls.com
133
137,5
87
27
46
43
,5
53
,7
23
,5
4
6,
5
12
13,
5
7
0
24,
5
63
M1
0
4
5
7
M
1
14
33
30…32
40
55
30
+
–
Q
V
396
380
65
40
The length of the bus cable is limited by the following parameters:
Number of devices connected
Cross-section of cable
The following table is valid for twisted-pair wiring:
Twisted-pair wiring
Cross section
Nbr. of devices Max. cable length
0.20 mm²
31
< 200 m
0.20 mm²
31
200…500 m
with bus termination
If shielded cables are used, the shielding must be earthed in accor-
dance with the main source of interface in the installation:
Single-earthed shielding is suitable as a protection against elec-
tric interference (e.g. from high-tension lines, static charges, etc.)
Double-earthed shielding is suitable as a protection against
electromagnetic interference (e.g. from frequency converters,
electric motors, coils etc.)
It is advisable to use twisted pairs.
Additional technical information
The upper section of the housing with the lid and the lid-release
button contains the electronics and the sensor. The lower section of
the housing contains the brushless DC motor, the maintenance-free
transmission, the lever to disengage the transmission and the shaft
adaptor.
Unused connections should be insulated; they should not be wired
to earth.
Note
The bus connections react sensitively to excess voltage and are
unprotected with respect to the power supply. If incorrectly wired
up, the device may incur damage.
CE conformity
EMC Directive
2004/108/EC
EN 61000-6-1
EN 61000-6-2
EN 61000-6-3
EN 61000-6-4
Dimension drawing
1.2 m
1.2 m
1.5 m
42x 67x 25 (mm)
Accessory
XAFP100F001
