Saunier Duval OPALIS 5, Руководство пользователя

Страница: 9 / 16

9
COMMISSIONING & LIGHTING - OPALIS 6
Diagram 5
Commissionning
●
With the front casing removed, fit the
temperature selector knob where applicable.
●
On tap models, fit the hot tap handle (red) to the
left hand spindle and the cold tap handle (blue) to
the right hand spindle.
●
Open all remote hot taps and on tap models
open the hot tap on the front of the heater.
●
Open the water service cock.
●
When all the air has been removed from the
system, close the taps and check all joints for water
soundness.
1
4
6
2
3
5
D
Des 034
OPALIS 6
Description
1 -
Pilot tube
2 -
Control knob
3 - Temperature selector
4 -
Pilot tube clip
5 - Drain plug
6 -
Pilot injector
D - Piezo unit
Lighting
●
Turn the control knob anti-clockwise as far as it
will go, the red flame (
a
) will line up with the mark
( b ) on the casing, see diagram 6.1 .
●
Fully depress and then release centre button
( c ), the button will remain semi-depressed, see
diagram 6.2
.
●
Press piezo igniter button ( D ) see diagram 5 . It
may be necessary to wait a few moments for the
gas to reach the pilot.
●
Wait 15 seconds and then fully depress and
release the centre button ( c ) of the control knob,
see
diagram 6.3
.
●
If the pilot flame should go out, wait 60 seconds
and repeat lighting sequence.
Mec 037a
Mec 037a
●
The heater is now ready for operation when
a hot tap is opened.
●
To turn off the heater, turn control knob clockwise
as far as it will go, the white mark (
d
) will line up with
the mark (
b
) on front panel, see
diagram 6.4
.
NB : To turn off the heater while button ( c ) is in pilot
position, see diagram 6.2 , press a second time, see
diagram 6.3
, and turn knob fully clockwise.
Mec 037a
b
a
c
c
Diagram 6.1
b
d
Diagram 6.4
Diagram 6.2
Diagram 6.3
Mec 037a