Table of Contents
Assembly Tools Required
Part Identifi cation
Hardware Identifi cation
Assembly Steps
Français
Español
Safety
Warranty
Hammer
Not actual size
No. 2 Phillips Screwdriver
WARNING
!
Use of a TV that is too heavy or large is hazardous. A TV that is too heavy will create a risk of a tip-over that can cause severe injury or
death. A TV that is too large for the available space might be accidentally pushed or bumped off the furniture, or subject to tip-over.
• Check the size and weight of your TV. Compare it to the diagram below –
before you begin assembly!
• This Sauder unit is designed for use with televisions weighing less than 95 pounds.
Never
use with a TV that weighs more.
• The size of the television, front-to-back and side-to-side, must fi t within the space defi ned in the diagram.
•
Never
place the front edge of the TV past the front edge of the TV support shelf (or stop molding – if equipped)
•
Never
allow the sides of the TV to extend past the side edges of the TV support surface.
• If the TV has a CRT picture tube, the picture tube cone may extend past the rear of the support shelf.
• Be sure to apply the warning label as instructed in the last assembly step. The label provides important safety related information.
3
4
5-23
24-27
28-31
32-34
35
Tip Shown Actual Size
95 lbs.
95 lbs.
18-7/8"
18-7/8"
47"
47"
411864
www.sauder.com/services
Page 2
Tape Measure
