5
109872
-
Position both
LONG SKIRTS (M)
and both
SHORT SKIRTS (N)
on edge as shown.
NOTE:
Be sure the METAL BRACKET (U) on each LONG SKIRT is positioned toward the floor. Be sure
the grooves in the SKIRTS are facing in as shown. Follow the diagram closely.
-
Slide two
FEET (R)
into the grooves in the
LONG SKIRTS (M)
and
SHORT SKIRTS (N)
as shown. You may need to
gently tap them in with your hammer. Follow the diagrams closely.
-
Now, fasten the
FEET (R)
to the
BOTTOM (H)
as shown. Use a
9/16” WAFER HEAD SCREW (AA)
through the
large hole in each
FOOT
and into the pre--drilled holes in the
BOTTOM.
NOTE:
Be sure to use the 9/16” WAFER HEAD SCREWS (AA). Start both SCREWS a few turns before
tightening either of them.
-
Next, fasten the
METAL BRACKET (U)
on each
LONG SKIRT (M)
to the
BOTTOM (H).
Use a
9/16” LARGE
HEAD SCREW (BB)
through each
METAL BRACKET
and into the pre--drilled holes in the
BOTTOM.
NOTE:
Be sure to use the 9/16” LARGE HEAD SCREWS (BB).
Be sure the
METAL
BRACKET (U)
on each
LONG SKIRT (M)
is
positioned toward the
floor.
FOOT (R)
FOOT (R)
SHORT
SKIRT (N)
9/16” LARGE HEAD SCREW (BB)
(2 used for the
METAL BRACKETS
)
9/16” WAFER HEAD SCREW (AA)
(2 used for the
FEET
)
BOTTOM (H)
Unfinished
surface
LONG
SKIRT (M)
SHORT
SKIRT (N)
www.sauder.com/services
