2
101702
LEFT
END (B3)
-
Slide a patented*
END MOLDING (O2)
onto the notched edge of each
END.
Carefully slide both
MOLDINGS
until the
MOLDINGS
are even with the top edge of each
END.
NOTE:
The MOLDINGS should overhang the surface with holes. If the MOLDING overhangs the
wrong surface, remove it and slide it on again. Slide the MOLDING off the notched edge in
the same direction that it was slid on.
*
U.S. Pat. No. 5,499,886
Slide the
END
MOLDING (O2)
onto
the notched edge.
END
MOLDING (O2)
END
MOLDING (O2)
Slide the
END
MOLDING (O2)
onto
the notched edge.
RIGHT
END (A3)
These edges
should be even.
www.sauder.com/services