10
101702
EXTENSION SLIDE (SS)
Push the black lever in and pull the
SLIDE
from the
RAIL.
EXTENSION RAIL (RR)
RIGHT
END (A3)
LEFT
END (B3)
-
Carefully stand your unit upright.
-
Separate the
EXTENSION SLIDES (SS)
from the
EXTENSION RAILS (RR).
To do this, fully extend the
EXTENSION SLIDE
and push down on the black release lever on the
SLIDE.
Now, pull the
SLIDE
from the
RAIL
so
you have two separate parts. Be prepared, the parts are greasy.
-
Be sure the inner cartridge of each
EXTENSION RAIL (PP)
(including the ball bearings) is fully extended as shown.
Fasten two
EXTENSION RAILS
to the
EXTENSION BLOCKS
on each
END
as shown using two
5/16” FLAT
HEAD SCREWS (TT)
through each
EXTENSION RAIL
and into the small holes in the
EXTENSION BLOCKS.
Refer to the following note for further instructions.
NOTE:
For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram to
the right. Then slide the inner cartridge of the EXTENSION RAIL in to find the other hole that
lines up with the hole in the EXTENSION BLOCK. Turn a SCREW into this hole.
NOTE:
There must be a CABINET ACTUATOR (W) above each RAIL on the RIGHT END (A3). Be sure
to check the location of the CABINET ACTUATORS before fastening the EXTENSION RAILS
to the EXTENSION BLOCKS.
Fasten the two
remaining
EXTENSION
RAILS (P)
to the
EXTENSION BLOCKS
on the
RIGHT END (A3).
EXTENSION
RAIL (RR)
EXTENSION
RAIL (RR)
SMALL
EXTENSION
BLOCK (G2)
Use this hole.
www.sauder.com/services
GOLD 5/16” FLAT HEAD SCREW (TT)
(8 used in this step)