SATO 6433-00, Инструкция по эксплуатации, Страница: 7 / 16

5
② Slide the cap to take it out from the sensor probe as shown in the figure
on the right.
(2) Installing the glass electrode protection bottle
①
Install the protection bottle to the sensor probe in the reverse order of removal.
②
Hold the sensor probe upright so as not to spill the standard solution in the
protection bottle. Turn the protection bottle clockwise while pressing the cap.
③
After installing the protection bottle, push in the sensor probe until its tip hits the
bottom of the protection bottle.
Note: Pay attention not to spill the standard solution in the bottle when installing or removing the glass
electrode protection bottle
* If the standard solution comes in contact with the skin (hand), immediately wash the contaminated
skin with running water. If the solution gets into the eyes, immediately rinse with water and consult a
doctor.
* If the standard solution in the bottle runs down, replenish the bottle with the phthalate pH standard
solution to protect the glass electrode from becoming dry. Adding distilled water, pure water or tap
water before storing is recommended.
. Auto Power-Off Function
When the unit is untouched for about 20 minutes, the auto power-off function is triggered. If you need a
continuous measurement, make sure to disable the function.

Release the Auto Power-off function
Press the PWR key while pressing on the HOLD / ▲ key.
When “ n ” character appears on the LCD, release the keys.
Then the Auto power-off function is released.
Cautions
When the unit gets turned off, disabled auto power-off function is no longer effective. Each time the power
is turned on, disable the auto power-off function.