Satec PM130E, Инструкция по установке и эксплуатации

Страница: 31 / 55

Chapter 4 Setup Menus
24
Use the up/down arrow keys to scroll to the desired setup
option. The value associated with this option is displayed in the
lower window.
To change the selected setup option:
Press to activate the lower window.
Use the up/down arrow keys to scroll to the desired value.
Press to store the new value.
Press to leave the value unchanged.
To store your new setup for the setpoint:
From the middle window, press .
To quit the setpoint setup without changes:
From the middle window, press .
To quit the setpoints setup menu:
From the upper window, press or .
NOTES
1. If your instrument is not equipped with the optional relay, then these
setup parameters will not appear on the display.
2. When you enter the setpoints setup menu at the protected level,
monitoring setpoints is temporarily suspended until you return to the
main setup menu.
3. Each time you select a new trigger parameter, the operate and
release limits are set by default to zero.
4. You will not be able to store your setpoint setup to the instrument if a
setpoint action is directed to a relay allocated for pulsing.
5. The setpoint action directed to a relay output can be overridden using
commands sent via communications. A relay can be manually
operated or released. When the relay reverts to normal operation, it
is automatically returned under setpoint control.
Table 4-4 Setpoint Setup Options (middle window)
Code Option Description
triG Trigger
parameter The measurement parameter or signal to be
monitored by the setpoint.
On Operate limit The threshold at which the setpoint becomes
operative.
OFF Release limit The threshold at which the setpoint is released
(becomes inoperative).
On d Operate delay Time delay (0.1 sec.resolution) before
operation.
OFF d Release delay Time delay (0.1 sec. resolution) before release.
Act Setpoint action The action performed when the setpoint is
operative.
SELECT
ENTER
ENTER
ENTER
ESC
ESC
ESC