Satec C191HM, Инструкция по установке и эксплуатации

Страница: 36 / 63

Chapter 4 Setup Menus 27
NOTES
1. If your instrument is not equipped with the optional relay, then this setup parameter
will not appear on the display.
2. You will not be able to store your setup in the instrument if you assigned a parameter
to relay output with a zero number of unit-hours per pulse.
3. If a relay you allocated for pulsing has been manually operated or released, it reverts
automatically to normal operation.
4. If a relay you allocated for pulsing has been engaged by an alarm/event setpoint, the
setpoint is automatically disabled.
4.6 Alarm/Event Setpoints Setup Menu
Your instrument provides 16 alarm/event setpoints that can monitor a wide
variety of events; in turn, these events can be programmed to trigger specific
actions. This menu is used to specify the events to be monitored by the
setpoints, and actions to be triggered by those events.
To program a setpoint, you might need to define up to six setup parameters
which include: the setpoint trigger parameter, operate and release limits, optional
operate and release delays, and the setpoint action. Table 4-6 explains the
setpoint setup parameters. For the entire list of available triggers and setpoint
actions, refer to Tables 4-7 and 4-8.
Example:
Trigger
parameter
Setpoint 1 is set to monitor the real-time high current
on phase 1 (the
trigger parameter).
Operate limit }
}
}
}
Release limit }
The
operate ( On ) and release ( OFF ) limits which
determine setpoint operation are defined as 1200A
and 1100A respectively.
Operate delay }
}
}
}
Release delay }
The
delays before operation ( On d ) and release
( OFFd ) are set at 5 seconds and 10 seconds
respectively.
SP 1
RHi.C1
triG
SP 1
5
On d
SP 1
10
OFFd
SP 1
1200
On
SP 1
1100
OFF
SELECT CHG
SEtP
ENTER ENTER