Satec C191HM, Инструкция по установке и эксплуатации

Страница: 12 / 63

Chapter 1 Introduction 3
Measured Parameters
Note: Real-time values are measured over 1 cycle of fundamental frequency; Average
values are of 8, 16 or 32 real-time values
Parameter Dis- Output
play Com Analog Pulse Alarm
Average Amps, Volts, Frequency $ = setup via PC
# = setup via panel
Average RMS voltage per phase L-N
√ √
#$ #$
Average RMS voltage per phase L-L
√ √
Average RMS current per phase
√ √
#$ #$
Average frequency
√ √
#$ #$
Average neutral current
√ √
#$ #$
Voltage & current unbalance
√ √
Amps & Volt Demand Parameters
Ampere demand per phase
√
#$
Volt demand per phase
√
#$
Ampere maximum demand per phase
√ √
Voltage maximum demand per phase
√ √
Average Power Values
Average active power per phase
√ √
Average reactive power per phase
√ √
Average apparent power per phase
√ √
Average total active power
√ √
#$ #$
Average total reactive power
√ √
#$ #$
Average total apparent power
√ √
#$ #$
Average power factor per phase
√ √
Average total power factor
√ √
#$ #$
Power Demand Parameters
Active power accumulated demand
√
#$ #$
Apparent power accumulated demand
√
#$ #$
Active power demand
√
#$
Active power sliding demand
√
#$
Apparent power demand
√
#$
Apparent power sliding demand
√
#$
Active power predicted demand
√
#$
Apparent power predicted demand
√
#$
Active power maximum demand
√ √
Apparent power maximum demand
√ √
Energy Per Phase
Active energy import per phase
√ √
Reactive energy import per phase
√ √
Apparent energy per phase
√ √
Total Energy
Total active energy import
√ √
#$