SATA SATAjet X 5500, Руководство по эксплуатации

Страница: 474 / 498

474
US
Operating Instructions SATAjet X 5500 RP/HVLP (DIGITAL)
rate method).
7.2. Adjustment of the Material Flow
[4-1], [4-2], [4-3]
und [4-4] - material flow control fully opened
Information!
With the material flow control fully opened, the wear of the fluid tip and
paint needle is reduced to a minimum. Please select the correct nozzle
size depending on the material to be applied and the required applica-
tion speed.
7.3. Adjustment of the Spray Fan Pattern
• Adjust flat fan (factory setting) [5-1] .
• Adjust round fan [5-2] .
7.4. Painting
Fully pull trigger for painting
[6-1]
. Operate spray gun according to
[6-2]
.
Maintain spray distance as described in chapter 2.
8. Cleaning the Spray Gun
Danger! Notice!
• Prior to cleaning, please disconnect the spray gun from the com-
pressed air circuit!
• Risk of injury due to unexpected leakage of compressed air or mate-
rial!
• Empty spray gun and gravity flow cup completely, dispose of paint
material appropriately!
• Disassemble and install components very carefully! Exclusively use
included special tools!
• Use neutral cleaning solution (pH value 6 to 8)!*
• Do not use acids, alkalines, bases, pickling agents, unsuit-
able regenerates or other aggressive cleaning solutions!*
• Do not soak spray gun in cleaning solution! *Cleaning solution
must never penetrate the air passages!
• Do not clean cover plate of the electronic pressure display with point-
ed, sharp or rough objects!