SATA SATAjet X 5500, Руководство по эксплуатации

Страница: 476 / 498

476
US
Operating Instructions SATAjet X 5500 RP/HVLP (DIGITAL)
9.1. Replacing the Nozzle Set
[7-1], [7-2], [7-3], [7-4], [7-5]
and [7-6]
Every SATA nozzle set consists of "paint needle" [7-1] , "air cap" [7-2]
and "fluid tip" [7-3] and has been hand-adjusted to provide a perfect
spray pattern. Lubricate both paint needle [7-1] in the paint needle area
(approx. 3 cm before the needle sleeve, paint needle spring) and material
flow control screw [1-11]. Therefore, always exchange the complete noz-
zle set. After installation, please adjust material flow according to chapter
7.2.
9.2. Replacing the Paint Needle Sealing
Steps: [8-1], [8-2]
and [8-3]
When paint material leaks from the self-tensioning paint needle packing,
it needs to be replaced. Remove trigger according to
[8.2]
. After disas-
sembly, check if the paint needle is damaged or replace the nozzle set, if
required. Make sure that trigger sleeve [8-2] is in correct position when
trigger is reassembled. Adjust material flow according to chapter 7.2 after
installation.
9.3. Replacing the Air Piston, Air Piston Spring
and Air Micrometer
Steps: [9-1], [9-2] and [9-3]
Danger!
• Disconnect the spray gun from the compressed air circuit!
This must be exchanged if air is leaking from the air nozzle or the air
micrometer while the trigger is not pulled. After disassembly, grease air
micrometer shell with SATA gun lubricant (item no. 48173), use with air
piston and tighten locking screw using original SATA combination tool
with max. 1 Nm. [9-1]. After installation, set material throughput according
to chapter 7.2.
Danger!
• Check if the locking screw has been firmly tightened! The air microm -
eter could shoot out from the spray gun uncontrolled!