SATA 97813, Руководство пользователя

Страница: 18 / 120

中文
EN DE RU KO PT JA ES 97813/97817/97818
18
Figure 2
III. Installation and operation:
Handle installation:
1
）
Tighten the screws to connect and install the upper and lower handles.
2
）
Release the positioning screw on the handle and insert the handle into the handle hole.
3
）
Tighten the positioning screw to complete handle installation.
Exhaust:
1
）
Release the oil filler screw but do not remove it
（
see Figure 2
）
.
2
）
Insert the handle into the handle hole
（
see Figure 1
）
.
3
）
Rotate the handle counterclockwise
（
see Figure 1
）
and turn on the oil return valve.
4
）
Rotate the handle clockwise, lift and press it, and repeat this operation several times quickly to discharge air from the oil circuit.
5
）
Tighten the oil filler screw
（
see Figure 2
）
.
Oil filling:
1
）
Remove the oil filler screw
（
see Figure 2
）
.
2
）
Align with the oil filler and slowly add qualified hydraulic oil
（
see Figure 2
）
until it is 0.6 cm from the oil filler
（
note: do not press
the operating handle when adding oil
）
.
3
）
Replace the oil filler screw and tighten it.
Jacking:
1
）
Park the vehicle on a firm and level surface, and stop the engine.
2
）
Rotate the handle clockwise and lower the jack. After the lifting arm reaches the lowest level, rotate the handle clockwise and close
Safety valve screw
（
cannot be opened
and adjusted by itself
）
Universal Joint
Hydraulic pump
Oil filler screw
（
not shown
）