SATA 97813, Руководство пользователя

Страница: 17 / 120

中文
EN DE RU KO PT JA ES 97813/97817/97818
17
This jack is covered by product liability insurance:
This jack complies with the latest version of ASME PALD-2014.
I. Safety precautions:
1
）
Before operation and use, be sure to carefully read and fully understand all the contents of these instructions. Incorrect operation
may result in personal injury or product damage.
2
）
Check the jack before each use. Do not use it in case of any loosened or damaged parts.
3
）
Select the jack with the proper loading capacity
（
tonnage
）
according to the gross vehicle weight.
4
）
Never use the jack in an overloaded state, or else any losses caused by an accident will not be covered by the insurance.
5
）
Unbalanced loading is not allowed. Never tilt a jacked vehicle as this is likely to result in safety hazards and cause damage to the
jack and vehicle.
6
）
Brake the vehicle and stop the engine before operation.
7
）
Always confirm that the support surface is a horizontal hard surface before operation so as to avoid potential hazards.
8
）
The jack can only be used for jacking and cannot be used for supporting. After jacking, matching jacks shall immediately be used to
support the vehicle.
9
）
The jack tray shall be carefully aligned with the supporting point of the vehicle chassis before jacking.
10
）
Never rotate the handle during jacking, as this will cause the oil return valve to become loosened and the supporting tray to fall.
11
）
Do not move the vehicle during operation.
12
）
During unloading and lowering, slowly rotate the handle counterclockwise to lower down the vehicle.
13
）
Do not work under or around a vehicle which is only supported by a jack.
14
）
Do not disassemble or modify the jack without permission.
15
）
Never adjust the safety valve without permission, or else any losses caused by an accident will not be covered by the insurance.
16
）
During operation, the operator shall wear safety goggles and working gloves conforming to the relevant national safety regulations.
II. Product diagrams:
Figure 1
Tray
Lifting arm
Oil filler screw
（
not shown
）
Universal joint
（
not shown
）
Hydraulic pump
Rear wheel
Handle
Handle hole