Cubis
®
MCA Operating Instructions
37
Installation
t
Pull the connection cable (1) between the control unit and the weighing module
out of the control unit’s retainer and unroll it .
t
Turn the device over again and place it on an even surface .
5.5 Connecting the Ethernet Cable
Material:
1 Ethernet cable
1 soft support base
Requirements
The weighing pan and the associated components have
not
been set up .
Procedure
t
If the control unit is attached to the weighing module: Turn over the device and
place on a soft surface .
t
If the control unit is removed from the weighing module: Turn over the control
unit and place on a soft surface .
t
Remove the cover (3) of the Ethernet connection socket on the underside of the
display and control unit .
t
Plug the Ethernet cable into the Ethernet connection socket .
t
If the control unit is attached to the weighing module: Place the Ethernet cable
into the cable channel (1) and turn the cable lock (2) using the Ethernet cable .
t
If the control unit is removed from the weighing module: Place the Ethernet
cable in the cable channel .
t
Place the device back on the device base on a level surface .
5.6 Preparing Below-balance Weighing
The device can be configured for below-balance weighing . Samples can be
suspended for weighing using below-balance weighing, e .g . samples, which do
not
fit on the weighing pan .
For below-balance weighing, the hook must be installed in the device base and the
device set up on a weighing table with recess .
In legal metrology:
− The below-balance weighing equipment may
not
be used .
− The cover of the below-balance weighing equipment may
not
be opened .
Material:
1 soft support base
1 draft protection shield
1 weighing table with recess
1
2
1
3
