Sartorius BioPAT Xgas Vis, Руководство по эксплуатации

Страница: 59 / 79

Operating Manual BioPAT
®
Xgas Vis 59
Configuration Configuration
1
t
Select the ComPort, where the sensor is connected.
t
Check the field (Address Auto).
t
Press “Start” button.
t
Wait until the sensor appears (1).
t
Press “Stop” button.
t
Select the sensor from the list.
t
Press “Configure” botton.
NOTE
A few seconds after pressing the “Start” button, the message “Searching”
must appear in the upper left corner of the “Sensor Config” window.
− If this message is not shown, press “Start” button again.