21
Stand 12/2012 WBS / 10/2018 TM
SAFETY NOTICES
• Before the first start-up, read these operating instructions carefully and observe the information
given therein.
• Incorrect operation and improper handling can lead to malfunctions on the device and injury to the
user.
• Observe the accident prevention regulations applicable to the area of application and the general
safety regulations.
• Ensure a safe stand on a dry, non-slip surface that is adequate to the weight of the equipment. If the
ground is not stable enough, the unit may tip over and cause injury.
• Do not place the device on a hot surface and keep away from any heat source and direct sunlight.
• The ice cube maker may only be transported upright.
• Do not tilt the unit by more than 45 degrees.
• Do not move the device during use.
• Before moving the unit, unplug the power cord.
• Make sure that the device does not tip when moving. This could lead to injuries
• Keep packaging materials (plastic film) out of the reach of children.
• The unit may only be connected to a properly installed power outlet.
• Do not plug any other device into the same outlet. Make sure that the wall socket is plugged in.
• is generally accessible so that the device can be disconnected from the power supply in an
emergency.
• Do not use ice cubes produced in the first 2 hours.
• After longer transport, the unit should not be put back into operation until after 24 hours.
• Do not let the power cord hang over sharp edges and keep it away from hot spots, objects and open
flames.
• When unplugging the power cord, always pull the plug housing and never the cable. Turn off the
device before starting.
• Make sure that unintentional pulling on the cable or tripping over it is not possible.
• Do not damage or modify the power cord, pull, strain, bend or squeeze it, twist or roll it up.
• Do not clean the unit with an open water jet.
• The unit must not be immersed in water or other liquids or wetted with liquids.
• Do not place heavy objects or objects filled with liquids on the unit. Things could fall down and cause
injury. Liquids could be spilled, in the inside of the device and transmit electricity.
• Only use the original parts provided for this purpose when operating the unit.
• Never touch the device, cable or plug with wet hands.
Содержание EB 26
