Sargent and Greenleaf 2890C, Руководство по установке

Страница: 2 / 7

Document 630-881
Revised 09/17/2021
Copyright © 2021, Sargent & Greenleaf 2/7
Install (4) 1/4"-20 x 1/2" screws,
loosely fasten through door to
the exterior mounting plate
assembly.
Place a tabbed washer in
each of the (4) mounting
holes, with the small tab in
adjuster slot.
Level interior mounting
plate and exterior
mounting plate assembly.
B
1
B
2
B B
B
A
7 8 9
Center
punch and
pre-drill
mounting holes
(6x) using exterior
mounting plate
assembly holes as
guide. For steel
door drill Ø9/64",
for wood door drill
Ø1/8". Gauge hole
depth by length of
mounting screws.
A
A
4
Install (2) #10 sheet
metal screws and
tighten securely.
Center punch and
pre-drill interior
mounting plate
mounting holes (2x).
B
2
B
Tighten (4) screws
securely, making
sure both sides stay
B
B
10 11 12 13
Remove 2 screws to
release interior mounting
plate from mechanical
assembly.
6
From interior side,
use flat blade
screwdriver to
adjust (4) depth adjusters
until they are flush with
interior door face. Leave
each depth adjuster with
slot in vertical position.
5
Align
exterior
mount-
ing plate
assembly to
the through
holes on door
exterior.
Position
exterior
mounting
plate
assembly
flush against
exterior side
of door.
A
4
Heavy gage metal doors may
require tapped holes and machine
C
14 16
D
Install the rim
cylinder or
plug through
the exterior
escutcheon.
C
A
Slip the exterior escutcheon around
the handle and position over the
exterior mounting plate assembly.
15
A
4
A
Install (6) #10 sheet
metal screws and
tighten securely.
A
1
B
Position interior
mounting plate on door
and align with (4) depth
adjusters. Make sure
exterior spindle fits
through bottom center
hole.
B F
Locate the access control assembly,
remove (2) screws and temporarily
remove access control assembly. Set
Orient mechanical assembly, depending
upon specific application installation.
H
H
E
1
E
F
F
18 19
From door interior, install
the rim cylinder retainer
plate. Install (2) rim cylinder
mounting screws and tighten
securely. Check to make sure the
key turns easily, make rim cylinder
retainer plate adjustments as
needed to ensure smooth key
operation.
17
This unit accommodates retainer
plates with max thickness of 1/8"
and max diameter of 2-1/2"
Rim cylinder spindle must extend
5/8" to 1-1/8" from the surface of
door when installed.
B