Sanyo VCC-XZ600P, Инструкция по эксплуатации

Страница: 53 / 100

Use the / button to select [ALARM OUT], and press the SET button.
The ALARM OUT screen appears.
Use the / button to select [OUTPUT], and use the / button to enable/disable the alarm
output.
Available settings:
Use the / button to select [POLARITY], and use the / button to select the polarity for the
alarm output signal.
Available settings:
Use the / button to select [ALARM TIME], and use the / button to set the duration for
which the alarm signal is output.
Available settings: 2S, 5S, 10S, 15S, 20S, 30S, 45S, 1M, 2M, 3M, 4M, 5M, MANU (S: seconds, M: minutes)
Select [MENU] and choose “BACK” or “END” to complete the setting.
1
2
ON: Outputs the alarm signal.
OFF: Does not output the alarm signal.
REMOTE: Outputs the alarm signal by remote operation.
When selecting “REMOTE”, “MANU” is available for [ALARM TIME] enabling remote operation of the
alarm output using an external device.
Selecting [AUX6-ON] enables remote operation, and selecting [AUX6-OFF] disables remote
operation.
You can also turn on or off the alarm output using the system controller.
Press the [AUX ON] button to turn on the alarm output or the [AUX OFF] button to turn off the output,
and select “6” in the number entry screen.
While the alarm is output using remote operation, the alarm signal will not be output automatically
even when the alarm condition is detected.
3
NO (Normal Open): Normally open so closed condition is detected as output.
NC (Normal Close): Normally closed so open condition is detected as output.
4
5
53 / 100