Sanyo VCC-XZ600N - Network Camera - Weatherproof, Руководство по установке

Страница: 4 / 64

3
Installation method
■
Installing the camera to the ceiling or wall
Use commercially-available screws (M8x4) to secure the camera base by the four screw holes (A) .
Note regarding cable hole in wall
When installing the camera base, check the position of the cable hole (B) and pull the cable through it.
Refer to page 7 for details on connecting the cable.
If the mounting screws are too short, the camera may fall down. When installing the camera, the
length
(C) that the screw extends past the other side of the camera base should be 3 cm/1.2 in.
or more.
(A)
(A)
(A) (B)
(A)
(C)
(B)
(A)
1
1
2
Adjusting the camera position and angle
Use the accessory hexagon wrench (large) to loosen the screws of the part you would like to move,
and then adjust so that the lens faces in the direction of monitoring within an angle of ±45 degrees.
1 If the camera is adjusted to an angle of ±45 degrees
or more, the cables will become twisted inside the
camera and they may break.
2 Adjustment is possible within a range of 180 degrees.
3 After adjusting the positions, tighten the screws to the
following torques.
A: 2 N·m or more (8 places)
B: 4.3 N·m or more (2 places)
L5CE2_US(INSTALLATION).book 3 ページ ２００８年１月２３日 水曜日 午後４時８分