46
Appendix
Cleaning the Projection Lens
Apply a non-abrasive camera lens cleaner to a soft, dry cleaning cloth. Avoid using an excessive amount of cleaner.
Abrasive cleaners, solvents or other harsh chemicals might scratch a surface.
When the projector is not in use, close the front cover.
1
3
Lightly wipe the Projection lens with a cleaning cloth.
2
Follow these steps to clean the projection lens.
Warning Temp. Indicator
The WARNING TEMP. indicator flashes red when an internal temperature of the projector exceeds the normal temperature.
The indicator stops flashing when the temperature of the projector returns to normal.
When the WARNING TEMP. indicator continues to flash, check the items listed below.
Ventilation slots of the projector may be blocked. In such an
event, reposition the projector so that the Ventilation slots cannot
be obstructed.
Air Filter Care and Cleaning
The Air filter may be clogged with dust particles. Clean the Air
filter by following the section "Air Filter Care and Cleaning"
below.
1
2
If the WARNING TEMP. indicator remains on after performing
the above checks, the Cooling fans or the internal circuits may
be malfunctioning. Contact service personnel from an
authorized dealer or a service station.
3
AIR FILTER
Turn off the projector, and disconnect AC Power Cord from the
AC outlet.
Turn over the projector and remove the Air filter by pulling the
latch upward.
1
2
The removable Air filter prevents dust from accumulating on the surface of the projection lens and projection mirror. Should
the Air filter become clogged with dust particles, it will reduce the cooling fans’ effectiveness and may result in internal heat
build up and adversely affect the life of the projector. Clean the Air filter by following the steps below.
Clean the Air filter with a brush or wash out dust and particles.
3
Replace the Air filter properly. Make sure that it is fully inserted.
4
CAUTION
Do not operate the projector with the Air filter removed.
Dust may accumulate on the LCD panels and the projection
mirror degrading picture quality.
Do not put small parts into the Air intake vents. It may result
in malfunction of the projector.
Operating Environment
We recommend avoiding dusty/smoky environments when operating a projector.
When using under dusty or smoky conditions, dust may accumulate on the lens, liquid crystal panels, or optical elements
inside the projector. This condition may degrade the quality of a projected image and the life of the projector.
When the above symptoms are noticed, contact your authorized dealer or service station for proper cleaning.
LATCH
WARNING
TEMP.
LAMP
REPLACE
RE
READY
LAMP
MENU
INPUT
ON-OFF
SELECT
Warning Temp.
indicator
TOP CONTROL
Clean the Air intake vents with a vacuum cleaner at the same time.
AIR INTAKE VANTS
