Sanyo PLC XU78 - XGA LCD Projector, Руководство пользователя

Страница: 55 / 67

55
Maintenance and Cleaning
When the life of the projection lamp of this projector
draws to an end, the LAMP REPLACE indicator emits
a yellow light. If this indicator lights yellow, replace the
lamp with a new one promptly.
Lamp Replacement
WARNING:
TURN OFF THE UV LAMP BEFORE
OPENING THE LAMP COVER
Top Control
This indicator is yellow when
the life of the projection lamp
draws to an end.
For continued safety, replace with a lamp of
the same type. Do not drop a lamp or touch
a glass bulb! The glass can shatter and
may cause injury.
Allow a projector to cool, for at least 45
minutes before you open the Lamp cover.
The inside of the projector can become very
hot.
CAUTION CAUTION
Follow these steps to replace the lamp.
Turn off the projector and disconnect the AC power
cord. Allow the projector to cool for at least 45
minutes.
Remove screws of the lamp with a screwdriver
and pull out the lamp upwards vertically by
grasping the handle.
Replace the lamp with a new one and tighten the
screws back into position. Make sure that the lamp
is set properly. Replace the lamp cover and tighten
the screw.
Remove the screw with a screwdriver, and remove
the lamp cover.
Connect the AC power cord to the projector and
turn on the projector.
Reset the lamp replacement counter .
See "Lamp Replacement Counter" on the next
page .
1
2
3
4
5
6
ORDER REPLACEMENT LAMP
Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give
the following information to the dealer.
●
Model No. of your projector : PLC-XU75 / PLC-XU78
●
Replacement Lamp Type No. : POA-LMP115
Service Parts No. 610 334 9565
Lamp
Screw
Handle
Screw
Screw Lamp Cover